![]() ![]() Using the printer, you can print a wide variety of labels, name and visitor badges. Backing paper can be rewinded face out only. The Leitz Icon printer is the heart of your Icon Smart Labeling System. Once the programming procedure will be completed, turn ON the unit and it is ready to work. Keep “ON-OFF” button pushed until both LEDs will be blinking, than push “Backing Paper Rewinder” button. Once the programming procedure will be completed, turn ON the unit and it is ready to work.īACKING PAPER REWINDER Turn the unit off. the printer does not operate normally when the operating instructions are followed. Keep “ON-OFF” button pushed until both LEDs will be blinking, than push “Label Rewinder” button. Smart Label Printer 100/200/240 User Guide by Prestige Publications. Keep pushed “FACE IN” button and push “ON-OFF” until it beeps and the unit starts to rotate. Keep pushed “FACE OUT” button and push “ON-OFF” until it beeps and the unit starts to rotate. INCREASE SPEED Push this button to increase the rotation speed.ĭECREASE SPEED Push this button to decrease the rotation speed. ON-OFF Push this button to turn On or Off the unit. STEP 5 Stick the end on the cardboard core. STEP 4 Pull the printed media underneath the printer and under the tension arm. Slide in the outer disk onto the core holder and keep it close to the media edge. Load the empty cardboard core onto the core holder. STEP 3 Remove the additional support and the outer disk. Do not tighten the knobs until the rewinder will be properly aligned to the printer. STEP 2 On the back side, place and screw the rewinder to the printer plate. ![]() STEP 1 Place carefully the printer into the lock guides. If you do not have the printer plate (JPL-6000P), place and align the rewinder behind the printer and than follow the instructions from STEP 3. The unit is equipped with an extension plate as default, for this configuration it is not required to be used. STEP 11 Once the media is loaded on the rewinder, slide left and right the rewinder to find the correct alignment between the two units and tighten the knobs.ĪTTENTION. STEP 10 Keeping the printed media underneath the tension arm, stick the end on the cardboard core. STEP 9 Remove the additional support and the outer disk. ![]() STEP 8 Pull the printed media underneath both printer and label unwinder. Than screw the rewinder (C) to this plate extension.ĭo not tighten the knobs until the rewinder will be properly aligned to the printer. STEP 7 Behind the unwinder (A), place and screw the additional plate “B” (equipped with the rewinder). STEP 6 Once the media is loaded into the printer, slide left and right the unwinder to find the correct alignment between the two units and tighten the knobs.Ĭomplete the roll to roll system with the Label Rewinder Installation Please look at printer’s user manual and follow the detailed procedure on how to load the media into the printer. It does not store any personal data.STEP 5 Keeping the media underneath the tension arm, turn on the unwinder and feed the media into the printer. The cookie is set by the GDPR Cookie Consent plugin and is used to store whether or not user has consented to the use of cookies. The cookie is used to store the user consent for the cookies in the category "Performance". This cookie is set by GDPR Cookie Consent plugin. The cookie is used to store the user consent for the cookies in the category "Other. The cookies is used to store the user consent for the cookies in the category "Necessary". The cookie is set by GDPR cookie consent to record the user consent for the cookies in the category "Functional". The cookie is used to store the user consent for the cookies in the category "Analytics". These cookies ensure basic functionalities and security features of the website, anonymously. Necessary cookies are absolutely essential for the website to function properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |